Under Devices find the tablet’s name, and choose the mode to Screen. To make GIMP respond to pressure sensitivity, set up the input device as follows: Edit > Preferences > Input Devices, press Configure Extended Input Devices. It turns out that replugging the tablet to the USB jack is enough to get it up and running OK. Īccording to the reference mentioned above, there’s a need to relogin. Which is why the arrival now of affordable, serviceable tabs like the DigiPro WP8060 on the scene gives us kind of a bittersweet feeling. The names are slightly different, who cares). Paint, draw, write, sign, and sketch all your documents and applications This DigiPro WP5540 digital tablet comes equipped with a pressure sensitive stylus pen giving you the right tools for any task The tablet features a 5.5 x 4-inch working area with a pen holder and indicator and an attached USB cable. So I downloaded the recommended XML file from here, modified the variables according to my own calibration, and saved the following as /etc/hal/fdi/policy/99-wizardpen.fdi (and trashed the previous file. Golive Technologies - Offering PTH460 Wacom Intuos Small Pen Tablet, Size: 10.6 X 6.7 X 0.3 In in Ghaziabad, Uttar Pradesh. No need to restart X for new devices! Hurray! Instead of the mumbo-jumbo above, there is a new mumbo-jumbo, which is supposed to work even if the device is hotplugged. If you’ve edited an nf file, that should be old history. Now, one of the side effects of installing the wizardpen RPM package was that it created a file: /etc/hal/fdi/policy/99-x11-wizardpen.fdi which is a HAL fdi file. To some this goes with /dev/input/event8, just play with the numbers until hitting gold: # wizardpen-calibrate /dev/input/event6Ĭorner of your desired working area: ok, got 1928,3766Ĭorner of your desired working area: ok, got 30360,28914Īccording to your input you may put following
#Digipro pen tablet registration#
To get it going, I followed the solution in Fedoraunity (which requires registration to access, would you believe that!)įirst, I downloaded the wizardpen RPM package from here.Īnd installed it: # rpm -i wizardpen-0.7.86_64.rpmĪnd then ran the calibration utility. Jun 29 19:49:06 big kernel: usb 6-1: configuration #1 chosen from 1 choice Jun 29 19:49:06 big kernel: usb 6-1: Manufacturer: UC-LOGIC Jun 29 19:49:06 big kernel: usb 6-1: New USB device strings: Mfr=1, Product=2, SerialNumber=0 Jun 29 19:49:06 big kernel: usb 6-1: New USB device found, idVendor=5543, idProduct=0004 How do I know? Because when I plug it in, /var/log/messages gives: Jun 29 19:49:06 big kernel: usb 6-1: new low speed USB device using uhci_hcd and address 5 To the system, this tablet is UC-LOGIC Tablet WP5540U. Clicks worked OK, but it looked like the system needed to know the tablet’s dimensions. When plugging it in, the system recognized it, but every time I touched the tablet with the stylus pen, the cursor went to the upper left corner. I just bought a DigiPro 5″/4″ drawing tablet to run with my Fedora 12. This post was written by eli on June 29, 2010
0 kommentar(er)
